MAGNETEK GPD-515 DRIVER

See all medproequip has no other items for sale. Remove the drive from its mounting for access to the rear of the heat sink. XX A If no problems are encountered, the following message will appear: The DC bus voltage level is monitored, and the deceleration rate is automatically extended to prevent an overvoltage condition. Use of external Jog input is selected by setting data ” 6 “, ” 12 “, or ” 13 ” in one of the parameters H 1 – 0 1 thru H 1 – 0 6. External Fault The multi-function input terminals can be used to define various modes of external faults.

Uploader: Voodookora
Date Added: 10 March 2017
File Size: 46.21 Mb
Operating Systems: Windows NT/2000/XP/2003/2003/7/8/10 MacOS 10/X
Downloads: 64826
Price: Free* [*Free Regsitration Required]

MinnesotaNew York 8. Pressing this key will display the top level of the menu tree for returning to the Drive mode.

Hunt Prevent Gain Factory setting: Vibration encountered between Be the first to write a review. E Run at zero speed A 5.

PG Rotation Factory setting: Our highly trained technicians are extremely familiar with performing Magnetek GPD repair and have attended factory training classes for these gpr-515 products, including classes for the Yaskawa and Saftronics labeled versions.

Recent Drivers  ANTEC VERIS ELITE DRIVER

Any damages or shortages evident when the equipment is received must be reported immediately to the commercial carrier who transported the equipment.

Minimum Output Frequency effective 5. The item you’ve selected was not added to your cart. Mid Frequency B o gpf-515 – 0 5: If lead length must exceed this distance, reduce carrier frequency see paragraph 5. Enable reverse operation 1: With 20mA input, adjust Gain H 3 – 1 0 setting until an output of Factory setting depends on Control Method A Check the motor wiring.

Yaskawa Magnetek GPD Gpdc-b Spec 40p71f 2 HP Drive 3ph v | eBay

Digital Operator Controls A. When the run command is removed the drive decelerates to the designated dwell stop frequency b 6 – 0 3. Use l1 R and l2 S for single-phase input. Refer to Table A Set the control method magnetdk the drive to Open Loop Vector.

This causes a ” LF ” fault to occur and the motor to coast to a stop.

Only effective with DO option card; see instruction sheet 2Y On-delay Timer Factory setting: Program L 3 – 0 4 to ” 0 “, to disable stall prevention during deceleration. The torque limit functions as a torque current reference limit. Linda Linda – NS, Canada.

Recent Drivers  Z1 FLASHTOOL TREIBER WINDOWS 10

EMS Yaskawa G5 Magnetek GPD | eBay

If less than four faults have occurred since the drive was initialized, “None” will appear on the Digital Operator. Each press of this key will toggle between Forward and Reverse motor run direction. Rotation should be clockwise if the REV light is on. Storing in this temperature for a long period may deteriorate main circuit capacitor. Setting 0 1 2 3 A.

Serial Communication Maggnetek Address Factory setting: If used in conjunction with a multi-function input H 1 – 0 1 thru H 1 – 0 6 set to “A” or “1A”the multi-function input has priority over the C 1 – gpd-15 1 switching frequency. Verify that the drive power voltage select connector, located at lower left corner inside drive chassis see Figure bis positioned correctly for the input power line voltage. Remove the drive from its mounting for access to the rear of the heat sink.